bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about GMC Savana Van


  • Does The VanTred Custom Floor Mat Allow Totes With Casters To Roll Freely
  • The VanTred Custom Floor Mat for Cargo Vans # VTRG96 would allow totes with casters to roll around easily so you'd need to lock the casters or find a way to hold the totes in places with a strap or bungee cord. Since this mat has a closed cell polypropylene layer to cushion the top you'll also see tracks wherever the totes sit and roll, depending on how heavy they are.
    view full answer...

  • Are Trailer Tire/Wheel Combos Factory Balanced
  • Our tire and wheel combinations like the # TA43RR from Taskmaster that you looked at are mounted at the factory so that the high heavy spot on the tire is aligned with the low light spot on the wheel. This will typically provide adequate balance for trailer tires, since trailers don't have a steering axle. If you wish to take them to your local tire shop for balancing, you certainly may do so.
    view full answer...

  • Installing Tekonsha Brake Controller On A 2020 GMC Savana Cutaway
  • I can definitely point you in the right direction. These Savana models can be tricky when installing a dash mount brake controller like the Tekonsha P2 # 90885. If the vehicle has the factory tow package with a 7 way plug, there should be a blue wire for output run under the dash. It would be located near the emergency brake pedal. Some models will have the connection wiring taped and tucked under the driver side floor mat up towards the firewall. Those wires would be labeled which is...
    view full answer...

  • Capacity of Trailer Connector 12-Volt Trailer Accessory Circuit On 2011 GMC Savana Van
  • I looked at the fuse diagram for your 2011 GMC Savana, and the fuse capacities weren't listed. Typically, that circuit is protected by a 40A fuse, so it'd be safe to say that the 12-V auxiliary circuit that feeds the 7-way trailer connector would be limited to a 40A capacity. This being said, due to the distance between the alternator and the 7-way and the small gauge of the wire feeding that circuit, using that 12-V accessory circuit to run your DC to DC charger wouldn't be very effective. You...
    view full answer...